Genie Intellicode Remote   Press and release the learn code button on the receiver, while the red LED is blinking, press your transmitter button 3 times. This will lock in a new code and you will be able to use your remote controls normally. Repeat this process for each additional remote control you have.

	Liftmaster Security + Remotes   A remote control with a yellow light or no light on the front and no code switches inside are called "Security+®."  This is rolling code technology, meaning that each time you press the button on the front of the remote control, the code that it transmits to the garage door opener automatically rolls the code to any one of 100 billion codes, never to be repeated.  These remote controls will only work on Security+ garage door openers, which have a square orange/red Smart/Learn button. To program the remote control, first locate the orange/red smart/learn button. On our chain drive models, this button is on the end farthest from the door. On our belt and screw drive models, it is on the right side as you face the door from the opener.  Push and hold the button on the new remote control and at the same time, push and release the orange/red smart/learn button.  Let go of the button on the remote control.  The remote should now be programmed. If you have lost a remote, you should erase all of the codes in the receiver by pressing and holding the orange/red Smart/Learn button until the yellow indicator light beside the button goes out. This will take approximately 6 seconds.  After you do this, you will then need to reprogram all of your existing remotes back into memory.  Simply hold the button on the remote control and at the same time, push and release the orange/red smart/learn button.  Let go of the button on the remote control.  Repeat this last step for each additional remote control. With some Security+®  models, you can also program your remote control or additional remotes, without climbing a ladder, right from your Multi-Function Control Panel. Simply press and hold the remote control button. Then press and hold the light button and the pushbutton on your Multi-Function Control Panel. The opener lights will flash to confirm that the remote control has been successfully programmed. As an added feature, Security+®  remote controls can be programmed to operate the garage door opener lights without opening the garage door. This feature can only be programmed using the Multi-Function Control Panel. With the garage door closed, press and hold the remote control button that you want to control the light. Secondly, press and hold the light button on the door control panel. Then press and hold the lock button on the door control panel. After the opener lights flash, release all buttons. Test this by pressing the remote control pushbutton. The garage door opener lights should turn on or off, but the door should not move.